RV and Camper Lighting
RV Lighting
Videos
for RV Lighting
Help Articles
for RV Lighting
Expert Answers
for RV Lighting
Hey Luke, thanks for reaching out! The Curt Custom Base Plate Kit #C56JR for your 2023 Ford F-250 Super Duty actually matches up with the Blue Ox system, but you can still use this with your Blackhawk2 tow bar if you get the Adapter Kit #RM-031.…
view full answer...Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…
view full answer...Yes, you'd just need to reach out to a qualified welder and have them weld on spring seats like part #TRSS300 to the top side of the Trailer Axle Beam with Easy Grease Spindles #e45GR. It's super common to do for people who have an…
view full answer...Yes, the red wires of the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger - 35 Amp #PD4135K are going to be labeled with a 3-digit code with 001 being the wire for your battery's positive post and 002…
view full answer...According to the instructions for the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4135K, the negative side of your battery will need to be connected to the backside of the converter. I have attached a…
view full answer...According to Progressive Dynamics, with the 35 amp Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4135K you will need 8 gauge wire. I have added a link to a video review for you to check out as well.
view full answer...The Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger - 35 Amp #PD4135K uses a 30 amp main breaker and 20 amp branch breakers, as you can see by the cut out of the linked directions I added.
view full answer...Yes, all you'll need to do is disconnect the three wires running from the converter section in your Progressive Dynamics 4100 #PD4135K from the AC distribution panel (circuit breaker, ground bus bar, neutral bus bar). This will cut the power…
view full answer...The black wire you have shown is power for the converter that's built inside the Power Center #PD4135K. You'll need to wire it to a 15 amp circuit breaker on the AC side of the power center.
view full answer...The white wire on the back of the Progressive Dynamics 4100 Series RV Converter #PD4135K just needs to be ran to the negative terminal on the battery.
view full answer...The Torflex Lift Kit #K71-707-02 may be exactly what you need for your Winnebago Micro Minnie 1706FB with tandem torsion axles but we do not have any database of axles and I was unable to find the specific axles on your trailer in my research. This…
view full answer...Due to the limits of trailer taillight wiring circuits your Hollywod Racks Safety LED light bar part #HLY54RR is functioning properly. The turn signals and the stoplights are all on the same circuit so the lights are going to all light up when you…
view full answer...